Publicidad
Idiomas disponibles
Idiomas disponibles
Before measurement, read the section "Notes for Accurate Measurement"
on page 16.
Normal Measurement
1.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2.
Press the
START
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is normal
for the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of the
display, during the inflation.
Note: If you wish to stop inflation at any time,
press the
3.
When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
To avoid re-inflation, see the
section "Measurement with the
SET Pressure" on the next page.
4.
When the measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
5.
Press the
START
After one minute of non-operation,
the device will turn off automatically.
Note: Allow at least three minutes between
measurements on the same person.
Measurements
button.
button again.
START
(heart mark) blinks,
button to turn the device off.
English 14
At heart level
Press
All of the display
segments displayed
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Systolic pressure
Diastolic pressure
WHO classification
Pulse rate
Exhausts remaining
air automatically
START
Publicidad
