Dreame Bot L10 Prime Manual De Instrucciones página 6

Product Overview
EN
Base Station
Upper Cover
Used Water Tank Clean Water Tank
Washboard
Water
Tank Clip
Float Ball
Used Water Tank Clean Water Tank
7
Water Tank Clip
Water Pipe
Filter
Floater
Before Use
1. Remove the Protective Strips and Install the Accessories
Side Brush Clip
Status Indicator
· Solid white:
Protective Strip
The base station is connected
to power
· Blinking Orange:
The base station has an error
Signaling Area
Note: Install the side brush until it clicks into place.
2. Set up the Base Station
Charging Contacts
Place the base station in a location that is as open as possible with a good Wi-Fi
signal. Insert the power cord into the base station and plug it into the socket.
Firmly insert the power
cord upwards until the
indicator turns on.
Note:
·
Make sure that no objects might block the signaling area.
·
To prevent water stains from damaging wood floors or carpets, it is
recommended to place the base station on tile or marble floors.
3. Place the Robot
Press and hold the button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward the
washboard. Then you will hear a voice notification when the robot successfully
connects to the base station and starts charging.
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
Mop Assembly
the robot with the station to charge it.
4. Add Water to the Clean Water Tank
Take out the clean water tank from the base station, and fill it with clean water
up to the max water line. Then install it back into the base station.
>1 m
＞5 cm
＞5 cm
＞1,5 m
Note:
·
Do not fill the water tank with hot water as this may cause the water tank to warp.
·
Do not add any liquid other than the officially-approved cleaning solution to
help prevent base station malfunction.
EN
MAX Water Line
8