Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting with Dreamehome App
EN
This product works with the Dreamehome app which can be used to control
your device.
Scan the QR code on the robot, or search for "Dreamehome" in the app store to
download and install the app.
QR Code
2. Add Device
Open the Dreamehome App, tap "
" in the upper right corner, and scan
the QR code above again to add "DreameBot L10 Prime". Please follow the
prompts to finish the Wi-Fi connection.
Wi-Fi Indicator
· Blinking slowly: To be
connected
· Blinking quickly: Connecting
· On: Connected
9
Note:
• Only 2.4GHz Wi-Fi is supported.
• Due to upgrades in the app software, the actual operations may differ
from the directions in this manual. Please follow the instructions based on
the current app version.
3. Reset Wi-Fi
Simultaneously press and hold the
and
buttons until you hear a
voice prompt say, "Waiting for the network configuration." Once the Wi-Fi
indicator is blinking slowly, the Wi-Fi has been successfully reset.
Note: If your robot cannot connect to the app successfully, reset the Wi-Fi and
add the device again.
How to Use
Fast Mapping
After configuring the network for the first time, follow the instructions on the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Turn On/Off
Press and hold the button for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base, the robot
should turn on automatically and begin charging. To turn off the robot, move
the robot away from the base and press and hold the button for 3 seconds.
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters sleep
mode. The power indicator and charging indicator will turn off. Press any
button on the robot or base, or use the app to wake up the robot.
Note:
· The robot will turn off automatically if it is left in sleep mode for more than
12 hours.
· If the robot is paused and placed onto the base station, the current
cleaning process will end.
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator will go out. The
DND mode is disabled by default at the factory. You can use the app to enable
the DND mode or modify the DND period. The DND period is 22:00-8:00 by
default.
Note:
· The scheduled cleaning tasks will be performed on time during the DND
period.
· The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, briefly press the button
to enable spot
cleaning mode. In this mode, the robot will clean a square-shaped area of
1.5 × 1.5 meters around it and return to its starting point once spot cleaning is
completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the
button for 10 seconds to force a shutdown. Press and hold the
button for 3
seconds to turn the robot back on.
EN
10
Publicidad
