Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Main Brush, Side Brush and Universal Wheel
1. Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
2. Pull out the brush covers as shown in the diagram. Use a proper tool to
remove the hair tangled in the brush.
3. Remove and clean the side brush.
4. Use a tool such as a small screwdriver to separate the axle and tire of the
universal wheel. Do not use excessive force.
5. Rinse the universal wheel under the running water and put it back after
drying it completely.
2
1
13
Filter
1. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, finger, or any sharp
3
objects so as to avoid damaging it.
2. Rinse the dust bin and filter with water and dry them completely before
reinstalling.
Note:
·
Rinse the dust bin and filter with clean water only. Do not use any detergent.
·
Use the dust bin and filter only when they are completely dry.
Routine Maintenance
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft, dry cloth:
Cliff Sensors
24h
Note: Wet cloth can damage sensitive elements within the robot and the base
station. Please use dry cloth for cleaning.
Charging Contacts
Clean the charging contacts and the signaling area of the base station with a
soft, dry cloth.
Laser Distance Sensor (LDS)
Edge Sensor
Bumper
Charging Contacts
Mop Pad
Remove the mop pad from the mop pad holder to replace it.
Carpet Sensor
Battery
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of time,
turn it off and put it away. To prevent damage from over-discharging, charge
the robot at least once every three months.
EN
14
Publicidad
