BSV BS POOL PRO200 Manual De Usuario página 45

3.2.3.2 Kit AUTO connection
Once the equipment (1) is installed, the following connections should be done.
1- Place the flange (10) in the pipe as indicated in the hydraulic connection
diagram. The flange (10) corresponds to the injector and should be connected
after the electrolysis cell.
2- Place the flange (7) in the pipe as indicated in the hydraulic connection
diagram. The flange (7) corresponds to the PH probe and should be connected
after the electrolysis cell and before the filter.
3- Connect one end of the suction tube (2) to the PH control inlet (11). 4-
Connect the other end of the suction tube (2) to the suction filter (4). 5- Place
the suction filter (4) inside the ACID drum.
6- Connect one end of the suction tube (3) to the PH control inlet (12).
45 / 66
Manual PRO200-IP65 v1.0