Cramer 82ZT132 Manual De Instrucciones página 12

EN
6.3.2 CHARGING RECOMMENDATIONS
Do not smoke while servicing the batteries.
Always wear safety glasses and protective clothing near
battery. Use insulated tools.
Charging recommendations
• Battery packs do not develop a memory and need not be
fully discharged before recharging.
• Batteries left uncharged will slowly discharge. Before
initial use each spring season, be sure batteries have a
full charge before mowing.
• If charger is not left plugged in, the batteries should be
fully charged every 30 days to maintain battery life.
Never allow charger to charge more than 15 hours.
• When charging, be sure charger cooling fan inlet and
outlet are not blocked.
6.3.3 CHARGE THE BATTERY
More details of charger are referred to in the charger
manual. Read and understand all its safety warnings and
instructions. Failure to follow them may result in electrical
shock, fire and/or serious injury.
1. Press the push button switch.
2. Remove the magnetic bar and make sure the machine
comes to a complete stop.
3. Remove the dust cap from the battery charging port on
the mower.
4. Plug the charger into the port.
5. Plug other end of charger into household GFCI protected
outlet.
Always turn charger "OFF" before disconnecting charger
from mower. Disconnect charger cord from wall outlet.
Cover the battery charging port with the dust cap before
operation.
6.4 DIGITAL DISPLAY
The function of the digital display, located on the control
panel, is to provide electrical system information to the
operator. It gives detailed information in the form of pattern,
codes and number.
WARNING
WARNING
CAUTION
WARNING
WARNING
WARNING
English
6.4.1 DIGITAL DISPLAY (FOR 82ZT132
SERIES)
# Name
1
2
3
4
5
6
7
8
9
10
11
12 Total hours Total working hours
13 Overall sta-
tus
14 Cutting
hours
15 L
A
BMS
R
B
M
12
Function
Low drive speed
High drive speed
Seat switch
Left control lever
Right control lever
PTO switch
The whole machine is OK
Need to restart
Low blades speed
Blade working
Battery remaining capacity
Overall status
Cutting hours
Left blade motor fault code
Master controller fault code
Battery fault code
Right blade motor fault code
Slave controller fault code
Middle blade motor fault code