Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
:
Pull the hand guard (6) back toward
the front handle.
Wear work gloves to protect your
hands from the sharp cutters.
:
Fit the chain – start at the bar nose.
30
6
9
:
Fit the guide bar over the studs (7) –
cutting edges on top of bar must
point to right – and engage the
peg of the tensioner slide in locating
hole (8) –- place the chain over
sprocket (9) at the same time.
:
Press down the throttle trigger
interlock to release the chain brake.
:
Now turn tensioning screw (10)
clockwise until there is very little
chain sag on the underside of the
bar –- and the drive link tangs are
located in the bar groove.
:
Refit the sprocket cover –
and screw on the nuts only finger-
tight.
:
Go to "Tensioning the Saw Chain".
Mounting the Bar and Chain
(Quick Chain Tensioner)
7
7
8 10
:
:
:
1
3
2
Pull out the hinged handle (1) so
that it snaps into position.
Turn the wingnut (2) counterclock-
wise until it hangs loose in the
sprocket cover (3).
Remove the sprocket cover.
MS 280 C
Publicidad
