Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing Starter Rope
and Rewind Spring
1
1
1
1
:
Remove the screws (1).
:
Push the hand guard upward.
:
Pull the underside of the fan cover
away from the fan housing and
remove it downward.
2
3
4
:
Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
:
Carefully remove the rope rotor
with washer (3) and pawls (4) – do
not pull the rewind spring out of the
housing – take care to avoid injury.
MS 280 C
Starter Grip without ElastoStart
:
Use a screwdriver to pry the rope
out of the starter grip.
1
:
Remove the remaining rope from
the rotor and grip.
:
Thread the new rope through the
starter grip and tie a simple
overhand knot.
4
:
Pull the knot back into the grip.
English / USA
Starter Grip with ElastoStart*
5
:
Ease the cap (5) out of the starter
grip.
:
Remove the remaining rope from
the rotor and grip.
:
Thread the new rope through the
starter grip and tie a simple
overhand knot.
:
Pull the knot back into the grip.
:
Refit the cap in the grip.
*
see "Guide to Using this Manual"
51
Publicidad
