Kodak ABR2300 Manual Del Operador página 12

10
8 Exposure Mode Select Key
Depress as required to select either Auto or Manual Exposure Modes.
A green Led indicates that the machine is in Auto Exposure mode, while an off LED indicates that the
machine is in Manual Exposure mode.
Auto Exposure Mode:
Manual Exposure Mode: When the requisite image density is not obtained in Auto Exposure mode, use
9 Exposure Adjustment Key (Lighter)
Press as required to set the print image density in Auto or Manual Exposure Mode.
Press "Lighter" to make the image lighter.
10 Add Toner Indicator
Lights up when the Toner Cartridge has run out of toner.
11 Drum Dry Button
Press when the print image is blurred due to condensation formed on the surface of the PC Drum.
Pressing the Button energizes the machine for three minutes to dry the condensation on the surface of
the PC Drum. If this Button is pressed when the print image density has become lighter it replenishes
the supply of toner, enabling the machine to resume normal print image density. Be sure to press this
Button whenever the Toner cartridge has been replaced with a new one.
12 Multi-Print Display
Shows the number of prints set to be made.
When a paper misfeed or malfunction occurs, it shows paper misfeed code (P) or malfunction code (U,
C) together with a number that represents the location of the misfeed or the type of malfunction.
13 Clear/Stop Key
Press to clear a wrong print quantity entry; this resets the Multi-Print Display to"1".
During a multi-print mode, pressing this Button stops the multi-print cycle, and resets the Multi-Print
Display to "1".
Press also to enable machine to exit Drum Dry Mode.
14 Multi-Print Key
Press this key to increase the number of prints to be made. Each depression causes the number
displayed to be incremented by 1. Continual depression causes incrementation up to 20, i.e. the
maximum number of prints which can be set.
15 Print Key
Press to make a print of the image currently on Screen.
The machine detects the image density of the film and prints at optimum
density. Use Exposure Adjustment Keys to fine-adjust the density.
the Exposure Adjustment Keys to manually select the requisite density.