Kodak ABR2300 Manual Del Operador página 41

REPLACING THE PROJECTION LAMP
If the brightness on the Screen is drastically reduced or when the Projection Lamp is burnt out, replace the
Lamp with a new one by following the procedure given below.
CAUTION
Be careful: the Lamp is very hot immediately after the power has been turned OFF. Wait until it cools down.
Turn OFF the Power ON/OFF Switch and slide
the Projection Unit out of the machine.
Remove the Projection Lamp from the Lamp
Holder.
NOTE
Never touch the Lamp with bare hands
immediately after the power has been turned
OFF. It is extremely hot.
Remove the Projection Lamp from the Lamp
Socket.
39