Publicidad
Idiomas disponibles
Idiomas disponibles
5. To light other burner, push and turn control knob to "HIGH".
6. If burner does not ignite using the igniter, see "Match Lighting the Main Burners" section.
7. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off the
gas fl ow from the cylinder.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Make sure all control knobs are in the "OFF" position.
3. Place a paper match in the end of the matchlighter. Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2" (1 to 2 cm) from the burner.
4. Turn on the LEFT main burner control knob to the "HIGH" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. To light other burner, push and turn control knob to "HIGH".
7. If the burner does not light within the fi rst few attempts of match lighting, there is
a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate
the grill until the problem is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and hold down the SIDE BURNER control knob and turn
SLOWLY (2 to 3 seconds) to "HIGH". You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light grill.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see "Match Lighting the Side Burner" section.
6. To turn off, turn control knob clockwise until it locks in "OFF" position.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Strike the match and place it approximately 1/2" (1 to 2 cm) from the burner.
4. Push and turn the side burner control knob to the "HIGH" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. If the burner does not light within the fi rst few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the side burner until the
problem is found and corrected.
Note: If burner does not light or fl ame is too low, See "Trouble Shooting" section of the owners manual.
Note: Observe fl ame height when lit: Flame should be a Blue/Yellow color
between 1"–2" when burner is on "HIGH".
See section in manual on burner adjustment to adjust fl ame.
Lighting Hole
Matchlighter
10
Publicidad
