Publicidad
Idiomas disponibles
Idiomas disponibles
9. TROUBLESHOOTING
4. INSTALLATION AND START-UP OF THE MACHINE
9.1 Introduction
4.1 Setting up the machine
For safety reasons, all interventions that involve accessing the electrical system and/or the removal of
Position the machine in a place suitable for its intended use which complies with all mandatory
the casing must only take place when the machine is stationary and the plug disconnected from the
safety conditions. The area must be equipped with sufficient lighting and aeration.
mains.
Position the machine observing the minimum distances from walls, as illustrated in fig. 5, to ensure
there is sufficient space for work, cleaning and routine maintenance operations. This will also allow
9.2 Solution to common problems
operators to work in safe conditions, avoiding any crushing and/or being dragged between the bowl
and the wall. When positioned as above, the machine is stable and does not require anchoring to the
Type of problem
floor.
The machine does not work
The motor won't start
Whistling at the end of the
processing phase
9.3 Support Services
4.2 Electrical power supply
If a fault or malfunction occurs on the machine, the user can contact the manufacturer's technical
The machine is equipped with one single electrical connection with a power cord at the back of the
support service for assistance.
machine; the system layout can be seen in the diagram supplied with the machine.
It is also necessary to provide the machine's identification data:
Check that the rated plate voltage corresponds to the main network voltage and the rated plate
- The model
power is equal or lower than the network power.
- The serial number
The connection must foresee coupling to a manual voltage disconnection switch, to allow the
- The year of manufacture
separation of the electric machine parts from the mains network when necessary (e.g. during
- The voltage
cleaning or maintenance). This device serves to transmit the correct rated current; the diameter of
- The frequency
the main network connection and external protection (earthing) cables must be proportional and
All this information is found on the machine rating plate.
adequate for the rated current.
Attach a retention plug to the end of the machine power cord suitable for the disconnection switch
installed and plug it into the socket.
Start the machine and check that the spiral mixer turns in the direction indicated by the arrow on the
front of the structure below the bowl. If this is not the case, invert the position of the two phase wires
in the plug. The machine does not require any other type of intervention and is now ready to use.
44
Possible cause
Machine not powered up
100 cm
electrically
The mobile guard limit
switch is adjusted incorrectly
The thermal protection has
been triggered
The motor is too hot
Unsuitable drive belt
tensioning
Plug the machine into the
10 cm
power socket
Call the technical support
centre for information on
adjustments
Allow the motor to cool
down
Tighten the belt
Solution
35
33
Publicidad
