WEG CFW700 Manual Del Usuario página 27

Keypad (HMI) and Basic Programming
Motor rotation
Menu (parameters
group selection) –
only one parameter
group is shown at
each time.
Parameter groups available at the Menu:
PARAM: all parameters.
„
READ: only the reading parameters.
„
MODIF: only the parameters changed compared to the factory default.
„
BASIC: basic application parameters.
„
MOTOR: parameters related to motor data control.
„
I/O: parameters related to the digital and analog inputs/outputs.
„
NET: parameters related to the communication protocol.
„
HMI: parameters for the keypad configuration.
„
SPLC: parameters related to the SoftPLC function.
„
STARTUP: parameters for the oriented startup.
„
Inverter status:
LOC: local reference.
„
REM: remote reference.
„
: motor rotation according to the arrows.
„
CONF: configuration. It indicates that the inverter is in the Oriented Start-up routine or with
„
incompatible parameter programming. Refer section Incompatibility Between Parameters in
the programming and troubleshooting manual of the CFW700.
SUB: DC link undervoltage.
„
RUN: inverter enabled and/or DC braking activated.
„
20 | CFW700
Local/Remote
(commands and
references source)
Main display
Figure 4.2: Display sections
Inverter status
Secondary display
Variable unit
(shows the value of
the main display)
Variable monitoring
bar graph