First Time Power-Up and Start-Up
Step
Action/Display Indication
15
If necessary, change "P0403 – Motor
Rated Frequency" parameter. This
change will affect P0402.
Press the
16
If necessary, change "P0402 – Motor
Rated Speed". This change will affect
P0122 to P0131, P0133, P0134, P0135,
P0182, P0208, P0288 and P0289.
Press the
17
If necessary, change "P0405 – Encoder
Pulse Numbe r" according to the
encoder model.
Press the
42 | CFW700
key to the next parameter.
key to the next parameter.
key to the next parameter.
Figure 5.1 (cont.): Oriented Start-up
Step
Action/Display Indication
18
If necessary, change "P0406 – Motor
Ventilation" parameter.
Press the
key to the next parameter.
The parameters to come after selecting
P0406 may vary according to the type
of control set at P0202.
19
If necessary, change "P0408 – Run
Self-Tuning" parameter.
Press the
key to the next parameter.
Run the self-tuning when running in
VVW and vector modes.
20
Press the BACK/ESC key to end the
oriented start-up routine.
Press the BACK/ESC again to go back
to the monitoring mode.