Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP
TREATMENT MODE PARAMETERS
ATTENTION!!!
ATTRITION OF PARTICLES DURING SHIPMENT
MAY RESULT IN INITIAL DUSTING AND SMALL
PARTICLE RELEASE. DUST AND ODOR WILL
DISSIPATE WITH USE.
Use the following instructions to set the various Mode Parameters to
the desired settings.
TREATMENT TIME
Press the "PRESS TO CHANGE MODE"
button until the indicator light is beside
"TREATMENT TIME".
NOTE:
The default time of "20:00" will be
displayed.
15 15
Fluidotherapy® - Dry Heat Therapy
Press the "INCREASE" or "DECREASE"
buttons until desired Treatment Time is
displayed.
NOTE:
The "TREATMENT TIME" can be adjusted in
one minute increments from 1 to 99.
TREATMENT TEMPERATURE
Press the "PRESS TO CHANGE MODE"
button until the indicator light is beside
"TEMPERATURE".
NOTE:
The default temperature of "115 °F (46.1 °C)
will be displayed when unit is first plugged
into wall outlet.
The "F" or "C" and "TEMPERATURE" indicator
will flash while the programmed Treatment
Temperature is being displayed.
When the Bed Temperature is displayed, the
"F" or "C" and the "TEMPERATURE" indicator
will illuminate steadily.
Publicidad
