MUHLER MLC-6050P Manual De Uso página 5

EN: PRESSURE MULTICOOKER | Instruction Manual
• Pressure regulator; if the fault of the pressure (temperature) control circuit occurs and the pressure in the pot exceeds the
maximum allowable value, the relief valve will automatically start to ensure the safety of the device.
• Discharge pressure component; if the pressure regulator has a fault and the pressure in the pot exceeds the maximum
allowable value, the discharge pressure component will discharge air along the edge of the pot cover to reduce the risk
pressure and prevent exploding.
• Temperature limit component; if the inner pot is empty, or the temperature exceeds the limit in the course of cooking,
the pressure cooker will automatically be power failure.
INSTRUCTIONS FOR USE
1. Open the pot cover
2. Hold the handle, rotate clockwise to stop, and then lift the pot cover (as shown in figure 1).
Fig.1
3. Before using, use the warm water to clean the inner pot. The total volume of food and water in the pot should not exceed
3/5 height of inner pot. For more hard food (chicken or mutton) with less water, the total volume should not exceed 4/5
height of inner pot. The minimum volume of food not less than 1/5 of the height of inner pot. (as shown in figure 2)
• When steaming rice, the amount of rice loading should not exceed 12 cups of rice.
• Under normal conditions, when steaming rice, one cup of rice should be matched with one cup of water. The ratio can be
adjusted according to personal preference.
4. Before cooking, clean up the inner pot and heating plate to ensure that they have no dirt. Slightly rotate the inner pot to
make it fit the heating plate (as shown in figure 3).
Fig.3
8
Fig.2
EN: PRESSURE MULTICOOKER | Instruction Manual
5. Cover the lid
• Ensure that the silicone gasket on the pressure cooker has no damage and ensure that internal aluminum plate can be
rotate freely by hand.
• Cover the lid, and turn the handle anticlockwise until you can hear the sound of jamming (as shown in figure 4).
Fig.4
6. Tear off the silver label attached on the discharge pressure valve to ensure that the valve can be put down and is able to
move freely. (As shown in figure 5).
7. As shown in the figure, put the water storage box into the pressure cooker.
Fig.6
8. After switching the pressure cooker on, there is the beep sound. 5 indicator lights on the control panel flash. At this
moment, the electric pressure cooker is in standby state.
FUNCTIONS: KEEP WARM/CANCEL:
When working, press this button to make the pressure cooker in the standby state. In standby mode, press this button into the
thermal insulation mode that will last for 24 hours. In thermal insulation state, keep the temperature of 65˚C~75˚C. During
this time, thermal insulation/cancel indicator lamp lights up. When the temperature reaches 100˚C, insulation indicator lamp is
normally on.
Fig.5
9