Dometic MWE9104 Instrucciones De Montaje Y De Uso página 12

EN
MWE9104
To connect 2 sensors proceed as shown (A,
To connect 3 sensors proceed as shown (B,
MWE9104F
To connect 2 sensors proceed as shown (A,
To connect 3 sensors proceed as shown (B,
13 Setting the system
NOTICE! Damage hazard
Incorrect settings can impair safe operation.
Note If no button is pressed for longer than 10 s, the settings menu is automatically closed without sav-
ing the changes.
Setting the values
To open the settings menu and set the values proceed as shown
Configuring the control module
MWE9104: Find an overview of the functions that can be set in
The factory settings appear in the column FACTORY.
MWE9104F: Find an overview of the functions that can be set in
The factory settings appear in the column FACTORY.
Tuning of the speed signal pulses
The driving speed limit at which the sensors switch on or off is 20 km/h and is controlled via speed signal. The
number of the speed signal pulses can be set specific to the vehicle.
Set function 8 to the required value for the number of speed signal pulses (pulses/s).
MWE9104F: Set function 9 to the required value for fine tuning the number of speed signal pulses (pulses/s).
This value is added to the value set in function 8.
Activating the engine noise filter
Set function 18 to the value 1 to activate the engine noise filter.
Setting the sensitivity of the sensors
MWE9104: Set function 43 to the required value (–9 = low ... +9 = high).
MWE9104F: Set function 23 to the required value (–9 = low ... +9 = high).
Setting the range of the sensors
MWE9104
Set function 45 to the required value to set the range of the middle sensors.
12
Fig.  on page 2 ).
Fig.  on page 2 ).
Fig.  on page 2 ).
Fig.  on page 2 ).
Fig. 
Fig. 
Fig. 
on page 3 .
on page 4 .
on page 4 .