ABACUS CONTENTS
1
GENERAL PRESCRIPTIONS
1.1
Safety prescriptions
1.2
Installation prescriptions
1.3
Operating prescriptions
2
MODELS AND PRODUCTS DESCRIPTION
2.1
Description
2.2
Typical installation
3
PRODUCT TECHNICAL SPECIFICATIONS
4
INSTALLATION
4.1
Preliminary checks
4.2
Operating limits
4.3
Preparatory work for installation
4.4
Installing the ABACUS operator
4.4.1 Installation
4.4.2 Limit stops installation
4.4.3 Operator manual release
5
PREPARATION FOR ELECTRICAL CONNECTIONS
6
TESTING
7
PRODUCT MAINTENANCE
8
SPARE PARTS
9
DISPOSAL OF THE PRODUCT
10
WARRANTY
1 PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
This installation manual is addressed exclusively
to professionally skilled personnel. Read all
the instructions carefully before starting the
installation procedures. Any operations that are
not expressly set down in these instructions
are to be considered prohibited; improper use
may result in damage to the product and place
persons and property at risk.
The manufacturer declines all liability for failure
to observe best practices in gate construction
and for any possible deformation that may
occur during use of the product. Store this
manual in a safe place for future reference.
The design and construction of the devices of
which model ABACUS is composed and also
this manual are in full compliance with statutory
legislation. In consideration of potential hazards
that may arise during the installation and use
of ABACUS, also the installation procedures
must be carried out in full compliance with the
applicable laws, standards and regulations;
namely:
1.2 INSTALLATION PRESCRIPTIONS
• Before starting the installation procedures
make sure you have any additional devices
and materials that may be required to
complete
the
automation
ABACUS in consideration of the specific
application.
• Dispose
of
packaging
compliance
with
system
with
materials
in
local
regulations.
1.3 OPERATING PRESCRIPTIONS
• No modifications can be made to any part of
the product unless specified in this manual.
Unauthorized modification of the product is
likely to lead to malfunctions and risks.
The
manufacturer
for
damage
caused
modifications.
• The parts of the automation system must
never be immersed in water or other liquids.
During the installation procedures ensure
that no liquids penetrate inside the control
unit or other open devices.
• If
liquids
penetrate
automation system disconnect the electrical
power supply immediately and consult
technical service; the use of ABACUS in
such conditions may give rise to potentially
hazardous situations.
• Keep all parts of ABACUS away from heat
sources and open flames; exposure to heat
or flames may damage the devices and
cause faults, fire, or hazardous situations.
• When the equipment remains unused for a
long time, remove the optional battery and
store it in a dry place to avoid the risk of
leakage of harmful substances.
• Connect the control unit exclusively to an
electric power supply line equipped with an
efficient protective earth conductor.
• Any operations that require the housing of
ABACUS to be opened must be performed
with the control unit and the electrical power
supply disconnected; if the disconnect device
is not clearly visible, attach a warning notice
to the effect: "WARNING - MAINTENANCE IN
PROGRESS".
• In the case of tripping of circuit breakers or
blowing of fuses, find the fault and remedy
it before resetting the circuit breaker or
changing the fuse.
• If the fault cannot be remedied using the
information given in this manual, consult
technical service.
2 PRODUCT DESCRIPTION
AND INTENDED USE
2.1 PRODUCT DESCRIPTION
Electromechanical rod operator for residential gates. The rugged die cast
aluminium structure can accommodate brush motors or single phase
motors, so the operator can be supplied in either a 24V version or a 230V
version. Aluminium housing with weather resistant powder coating.
COMUNELLO ®Copyright 2016 - All rights reserved
declines
all
liability
by
unauthorized
any
parts
of
the
17