Canon imageRUNNER ADVANCE 500i Guía De Inicio página 36

05
Setting the Date and Time
1. Select the time zone from the <Time Zone>
drop-down list.
2. Enter the current date and time using
– (numeric keys) → press [OK].
Enter the day and the month using four
digits (including zeros). The time is
displayed in 24-hour notation.
Examples:
May 6 → 0605
7:05 a.m. → 0705
11:18 p.m. → 2318
If you make a mistake when entering
values, press
again, starting with the day.
NOTE
• The standard time zones of the world are expressed
globally in terms of the difference in hours (± up to
12 hours) from GMT (± 0 hours). A time zone is a
region throughout which this time difference is the
same.
• If you set Daylight Saving Time, specify both the
starting and ending date in [Start Date] and [End
Date]. The machine automatically sets the standard
time of the machine one hour forward at the
specified date and time.
28
Using the Setup Guide to Configure the Machine
(Clear) → enter the values
06
Setting an IP Address
You can perform the following settings in order
to connect to and use a TCP/IP network with
the machine. Set IPv4 here.
1. Set <Use IPv4> to 'On' → set <Use IPv6> to
'Off' → press [Next].
2. Specify each setting → press [OK].
For manual entry:
●
When the network administrator connects
to a network where each machine has a
fixed IP assigned to it, the IP address must
be set manually.
If you do not know the IP, contact your
administrator.