Canon imageRUNNER ADVANCE 500i Guía De Inicio página 51

03
Load the paper stack into the paper
drawer.
1. Make sure that the paper size setting of the
paper drawer matches the size of the paper
to load in the paper drawer.
2. Load the paper stack against the right wall
of the paper drawer.
3. Gently push the paper drawer back into the
machine until it clicks into place in the
closed position.
When returning the paper drawer to its original
position, be careful not to get your fingers caught,
as this may result in personal injury .
IMPORTANT
• Paper which is curled must be straightened out
before loading it into the paper drawer.
• You will not be able to make copies or print if you
load paper that exceeds the loading limit mark
( ), or if the paper drawer is not completely
pushed into the machine.
• Make sure that the height of the paper stack does
not exceed the loading limit mark (
• Always check that the paper drawers are in place.
NOTE
• Each paper drawer holds about 550 sheets of paper
(80 g/m 2 ).
• If there are instructions on the paper package about
which side of the paper to load, follow those
instructions.
• When the paper is loaded into the paper drawer, the
side facing up is the one printed on.
• If problems, such as poor print quality or paper jams
occur, try turning the paper stack over and reloading
it.
• For more information on the print direction of
preprinted paper (paper which has logos or patterns
already printed on it), see e-Manual > Copy.
• Rewrap any remaining paper in its original package,
and store it in a dry place, away from direct sunlight.
1,2
3
).
• If paper runs out and printing is stopped, load a new
paper stack. Printing restarts after the new paper
stack is loaded.
• If you print on the paper which has absorbed
moisture, steam may come out from the output area
of the machine. This is because the moist on the
paper evaporates when the high temperature is
applied when a toner is fixed to the paper. It is not a
malfunction. (This especially happens in low room
temperature.)
Adjusting a Paper Drawer to Hold a
Different Paper Size
If you want to load a different size paper into a paper
drawer, you can follow the procedure described below
to adjust the paper drawer guides.
When handling paper, take care not to cut your
hands on the edges of the paper .
01
Remove the paper loaded in the paper
drawer.
1. Press and release the button on the paper
drawer in which you want to adjust.
2. Grip the handle, and pull out the paper
drawer until it stops.
3. Remove all of the remaining paper.
3
2
1
Loading Paper
43