Makita MLT100 Manual De Instrucciones página 8

Sierra de banco
Ocultar thumbs Ver también para MLT100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To secure the blade in place, hold the outer flange with
the offset wrench, then tighten the hex nut clockwise
with the wrench. BE SURE TO TIGHTEN THE HEX NUT
SECURELY.
1
008771
CAUTION:
Be sure to hold the hex nut carefully with the
wrench. If your grip should slip, the wrench may
come off the hex nut, and your hand could strike
the sharp blade edges.
Installing blade guard
1
009029
009030
CAUTION:
Before installing the blade guard, adjust the depth
of cut to its maximum elevation.
Remove the center cover. Insert the riving knife into the
blade guard mounting portion (stay). Tighten the hex
bolts (A) with the provided wrench.
For both European and non-European type blade
guards
The riving knife installing location is factory-adjusted so
that the blade and riving knife will be in a straight line.
1. Wrench
2
2. Wrench
1. Blade guard
2
2. Riving knife
3. Blade guard
mounting
3
portion (stay)
1. Blade guard
1
2. Riving knife
2
However, if they are not in a straight line, loosen the hex
bolts (B) and adjust the blade guard mounting portion
(stay) so that the riving knife is aligned directly behind
the blade. Then tighten the hex bolts (B) to secure the
stay.
1
2
4
5
008776
CAUTION:
If the blade and riving knife are not aligned properly,
a dangerous pinching condition may result during
operation. Make sure they are properly aligned.
You could suffer serious personal injury while using
the tool without a properly aligned riving knife.
NEVER make any adjustments while tool is
running. Disconnect the tool before making any
adjustments.
There must be a clearance of about 4 - 5 mm
(5/32"-3/16") between the riving knife and the blade
teeth. Adjust the riving knife accordingly and tighten the
hex bolts (A) securely. Attach the table insert on the
table, then check to see that the blade guard works
smoothly before cutting.
1
2
009033
Installing and adjusting rip fence
1
009034
Install the rip fence so that the fence holder engages
8
1. Blade
6
2. These two
clearances
3
should be equal.
3. Blade guard
mounting portion
(stay)
4. Riving knife
5. Hex bolts (A)
6. Hex bolts (B)
1. Blade guard
4 mm-5 mm
(5/32"-3/16")
2. Riving knife
1. Lever

Publicidad

Tabla de contenido
loading

Tabla de contenido