Assembly Instructions; Description (Fig. A); Package Contents (Fig. B&C); Assembly (Fig. D) - Tunturi T20 Treadmill Manual Del Usuario

English
⚠ CAUTION
• NEVER use a RCD - Residual Current Device (U.S. ver.= GFCI) -
wall outlet with this treadmill. As with any appliance with a large
motor, the RCD/GFCI will trip often. Route the power mains
cord away from any moving part of the treadmill including the
elevation mechanism and transport wheels.
Grounding Instructions
This product must be grounded. If the treadmill's electrical system
should malfunction or breakdown grounding provides a path of least
resistance for electric current, reducing the risk of electric shock. This
product is equipped with a cord having an equipment-grounding
plug. The plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local codes
and ordinances.
⚠ WARNING
• Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the
product is properly grounded. Do not modify the plug provided
with the product if it will not fit the outlet; have a proper outlet
installed by a qualified electrician.

Assembly instructions

Description (fig. A)

Your treadmill is a piece of stationary fitness equipment used to
simulate walking or running without causing excessive pressure to the
joints.
Package contents (fig. B&C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in fig. C. Refer to the
section "Description"
‼ NOTE
• If a part is missing, contact your dealer.

Assembly (fig. D)

⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to prevent damage to
the floor surface.
• Allow at least 100 cm of clearance around the equipment.
• Refer to the illustrations for the correct assembly of the
equipment.

Workouts

The workout must be suitably light, but of long duration. Aerobic
exercise is based on improving the body's maximum oxygen uptake,
which in turn improves endurance and fitness. You should perspire,
but you should not get out of breath during the workout.
To reach and maintain a basic fitness level, exercise at least three
times a week, 30 minutes at a time. Increase the number of exercise
sessions to improve your fitness level. It is worthwhile to combine
regular exercise with a healthy diet. A person committed to dieting
should exercise daily, at first 30 minutes or less at a time, gradually
increasing the daily workout time to one hour. Start your workout at
low speed and low resistance to prevent the cardiovascular system
from being subjected to excessive strain.
As the fitness level improves, speed and resistance can be increased
gradually. The efficiency of your exercise can be measured by
monitoring your heart rate and your pulse rate.

Exercise Instructions

Using your fitness trainer will provide you with several benefits, it will
improve your physical fitness, tone muscle and in conjunction with a
calorie controlled diet help you lose weight.
The warming up phase
This stage helps get the blood flowing around the body and the
muscles working properly. It will also reduce the risk of cramp and
muscle injury. It is advisable to do a few stretching exercises as shown
below. Each stretch should be held for approximately 30 seconds, do
not force or jerk your muscles into a stretch - if it hurts, STOP
The exercise phase
This is the stage where you put the effort in. After regular use, the
muscles in your legs will become more flexible. Work to your but it is
very important to maintain a steady tempo throughout. The rate of
work should be sufficient to raise your heart beat into the target zone
shown on the graph below.

HEART RATE

200
180
160
140 TARGET ZONE
120
100
80
20 25 30 35 40 45 50 55
This stage should last for a minimum of 12 minutes though most
people start at about 15-20 minutes
The cool down phase
This stage is to let your Cardiovascular System and muscles wind
down. This is a repeat of the warm up exercise e.g. reduce your
tempo, continue for approximately 5 minutes. The stretching
exercises should now be repeated, again remembering not to force
or jerk your muscles into the stretch.
As you get fitter you may need to train longer and harder. It is
advisable to train at least three times a week, and if possible space
your workouts evenly throughout the week.
Muscle toning
To tone muscle while on your fitness trainer you will need to have the
resistance set quite high. This will put more strain on our leg muscles
and may mean you cannot train for as long as you would like. If you
are also trying to improve your fitness you need to alter your training
program. You should train as normal during the warm up and cool
down phases, but towards the end of the exercise phase you should
increase resistance making your legs work harder. You will have to
reduce your speed to keep your heart rate in the target zone.
Weight loss
The important factor here is the amount of effort you put in.
The harder and longer you work the more calories you will burn.
Effectively this is the same as if you were training to improve your
fitness, the difference is the goal.
Heart rate
Pulse rate measurement
(hand pulse sensors)
The pulse rate is measured by sensors in the handlebars when the
user is touching both sensors at the same time. Accurate pulse
measurement requires that the skin is slightly moist and constantly
touching the hand pulse sensors. If the skin is too dry or too moist,
1 6
MAXIMUM
85 %
70 %
COOL DOWN
AGE
60 65 70 75