Good Earth Lighting UC1357-RGB-04LFW-G Manual De Instrucciones

Mounting Bracket x3
Support de montage x3
Soporte de montaje x3
Linking Cord (24in) x3
Cordon de liaison (24 po) x3
Cable de enlace (24 pulgadas) x3
Puck Light x3
Lampe arrondie à faisceau ciblé x3
Luz de disco x3
Required/ Nécessaire/ Obligatorio
* Actual hardware may differ from illustration./ * La quincaillerie incluse peut être différente de l'illustration./ * Los aditamentos reales pueden diferir de los que se muestran en la ilustración.
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
ATTENTION
Use only Insulated staples, plastic ties, or included cord clips.
Route and secure the cords so that they will not be pinched
or damaged.
LEDs gradually emit less light over their lifetime.
Suitable for INDOOR damp locations ONLY.
EASY INSTALLATION COMMAND® STRIPS BY 3M
1
Red liner side
Clean surface with rubbing alcohol. Remove red liner. Press strip onto the back of each mounting bracket and function controller.
1
Remove black liner. Press mounting bracket to surface with tab towards you. Press firmly for 30 seconds. Alight puck light into mounting
2
bracket. Press function controller to surface with tab towards you.
Connect fixtures, function controller, and plug-in driver by using the provided linking cords. Mount to desired location within 5ft of the
3
electrical outlet. Use provided cord clips where additional wire management is needed. Clean area, peel backing o the clips and mount
where needed. Plug the plug-in driver into the outlet.
1
Kit de 3 disques d'éclairage enfichables WIFI RVB TCP (Página 3)
Kit de disco enchufable WIFI RVA TCC, paquete de 3 (Page 5)
Function Controller
Contrôleur de fonctions
Controlador de funciones
x3
ENGLISH INSTRUCTIONS
SAFETY INFORMATION
WARNING
LED light output is strong enough to injure human
eyes. Do not look directly at exposed LEDs.
Turn power o before servicing.
2
Sec
STRIP REMOVAL
2
SLOWLY
SAVE AND ATTACH RECEIPT HERE
3PK WIFI RGB CCT Plug in Puck Kit (Page 1)
Model / Model / Modelo #: UC1357-RGB-04LFW-G
Plug-in Driver (5 ft)
Dispositif d'entraînement enfichable (5 pi)
Accionador enchufable (5 pies)
x10
CAUTION
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
Do NOT use with an extension cord, use ONLY with power strips that have integral
overcurrent protection.
If screw mount, do NOT mount to surfaces less than 1/4in thick.
Not intended for recessed installation in ceiling or so ts.
DO NOT mount over ceilings/sinks or beds.
3
1
Never pull the strip away from the surface!
Always pull along the surface.
Stretch each strip slowly against the surface at
2
least 6" to release.
x4