Medisana ISA Instrucciones De Manejo página 24

GB
3 Operation
3 Operation
3.1
Insert/replace
batteries
3.2
Weight only /
"Step-on"-function
and change the unit
of weight
18
Before you start up your digital scale, insert the three provided 1,5V
batteries (type AA, LR6) into the device. To do this, open the battery
5
compartment beneath the device and insert the batteries. Make
sure the polarity is correct (as shown in the battery compartment).
Put the lid of the battery compartment back on and push it until it
clicks into place. Change the batteries when the battery change
symbol "Lo" appears inthe display
the display after the device is switched on.
WARNING
• Do not disassemble batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with
any of this parts, rinse the affected area with copious amoun-
ts of fresh water and seek medical attention immediately!
• If a battery has been swallowed seek medical attention
immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use
different types of batteries together or used batteries with
new ones!
• Insert the batteries correctly, observing the polarity!
• Remove the batteries from the device if it is not going to be
used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a
danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put
them in a hazardous waste container or take them to a
battery collection point, at the shop where they were
purchased!
1. Make sure the scales are on a firm, level surface. If you only want
to weigh yourself but have moved the scales just before, you must
first initialise the scales. To do this, press your foot on the middle
of the surfaceof the scales. "0.0" appears in the display. You
now may select the weight units (kg - lb - st) by pressing the UP-
2
and DOWN-buttons
ready for the "step-on" function. This procedure is not necessary if
you have not moved the scales.
2. Step onto the scales and stand still. The device switches on auto-
matically and the glassframe and display
1
The display briefly shows "0.0". You now may again select
the weight units (kg - lb - st) by pressing pressing the UP-
2
and DOWN-buttons
3. Your weight is measured, flashes twice and is then finally display-
ed.
1
or when nothing is shown in
BATTERY SAFETY INFORMATION
4
. When the scales switch off, they are
1
4
.
E
G
are lighting up in blue.
G
G