Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
Removing
Pull the locking sleeve 4 to the rear and hold while removing the tool.
Putting into Operation
Operation
Switching on: Press the on- o switch 10
Switching o : Release the on- o switch 10
Switching on/o in chiselling mode
To lock the pressed on/o switch 10, push the lock-on button 9 upward.
To switch o the power tool. Release the on/o switch 10 or when it is locked with the lock-on
button 9, brie y press the on/o switch 10 and then release it .
Working Instructions
Overload Clutch
If the drill bit becomes jammed or caught, the drive to the drill spindle is interrupted.
- Because of the forces that occur as a result, always hold the machine with both hands and
take a secure stance. The machine should be used only with an auxiliary handle.
Auxiliary Handle 6
You will be able to obtain a safe position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an anticlockwise direction.
Depth Stop 5
Loosen the winged screw on the auxiliary handle 6. Adjust the drilling depth on the depth stop
5. Retighten the winged screw.
7