Husqvarna 562XP Mark II Manual Del Usuario página 10

5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the right hand guard is not damaged.
3. Make sure that the throttle lockout operates correctly
and that it is not damaged.
4. Make sure that the start/stop switch operates
correctly and that it is not damaged.
5. Make sure that there is no oil on the handles.
10
Operation
Read and understand the
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to
of the saw chain on page 28 for instructions.
9. Tighten the bar nuts.
Note:
Some models have only one bar nut.
To assemble a spiked bumper
To assemble a spiked bumper, speak to your servicing
dealer.
6. Make sure that the vibration damping system
operates correctly and that it is not damaged.
7. Make sure that the muffler is correctly attached and
that it is not damaged.
8. Make sure that all parts of the product are correctly
attached and not damaged or missing.
9. Make sure that the chain catcher is correctly
attached.
10. Do a check of the saw chain tension.
3 4
6,8
2
To adjust the tension
10
7
1 9
2053 - 001 - 18.04.2023