Husqvarna 562XP Mark II Manual Del Usuario página 21

Heated handles (562 XPG Mark II)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
do a check of the throttle trigger and
throttle trigger lockout on page 23 .
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
To do a check of the
brake. Refer to
chain brake on page 23 .
Do a check of the chain catcher. Re-
To do a check of the chain
fer to
catcher on page 23 .
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar. Refer to
check of the guide bar on page 30 .
Make sure that the guide bar and
saw chain are getting sufficient oil.
2053 - 001 - 18.04.2023
Maintenance
Read and understand the
Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
31 .
Do a check of the starter, starter rope
To
and return spring.
Lubricate the needle bearing. Refer
To lubricate the needle bearing on
to
page 29 .
Remove burrs from the edges of the
guide bar. Refer to
the guide bar on page 30 .
Clean or replace the spark arrester
screen on the muffler. Refer to
a check of the muffler on page 24 .
Clean the carburetor area.
To do a
Clean or replace the air filter. Refer
To clean the air filter on page 26 .
to
Electrical carburetor heating (562 XPG Mark
II)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 22 .
Make sure that the clutch center,
clutch drum and clutch spring are not
worn or damaged.
Clean the spark plug. Refer to
a check of the spark plug on page
26 .
Clean the external parts of the carbu-
To do a check of
retor.
Do a check of the fuel filter and the
To do
fuel hose. Replace if necessary.
Do a check of all cables and connec-
tions.
Empty the fuel tank.
To do
21