Snap-On EEWB332B Manual De Operador página 31

1
2
3
4
Figure 32
Figure 34
Figure 35
Option 1: Readjust the tire on the rim
(normal program)
Readjust the wheel following the right direction
•
indicator and make a double mark on the right side
of the tire exactly perpendicular to and above the
main shaft
Remove the wheel from the machine
•
Readjust the tire on the rim until the double mark
•
coincides with the valve
Clamp the wheel on the balancer and readjust so
•
that the valve is exactly perpendicular to and above
the main shaft.
5
Press the ENTER key
•
position.
Reading OP.8 appears
Spin the wheel (START) (check run).
•
If balancing optimization (silent running) has been
carried out correctly according to the program cycle,
after the check run the machine automatically returns
to the type of weight positioning previously selected and
indicates the residual dynamic imbalance on the wheel.
Balance the wheel according to the readings.
•
Both optimization and balancing are accomplished.
Message E9
Message E9 means that at least one error occurred
during the optimization cycle. Press the STOP key (5)
to exit the optimization program and repeat optimization
if necessary.
Option 2: do not adjust the tire on the rim
Press the STOP key (5) to exit the OP program and
•
return to the balancing program.
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
•
Reading H0
Press the STOP key (5) to exit the OP program and
•
return to the balancing program.
The imbalance on the wheel is shown on the readout.
Balance the wheel according to the readings.
•
The optimum balancing optimization condition has been
achieved and cannot be improved.
Reading H2
Silent wheel running cannot be improved. However, it
is possible to achieve weight minimization (readings
with code UN.).
Option 1: Weight minimization
Press the
•
EEWB332B
(Fig. 38).
(Fig. 39).
(1) to acquire the valve
(Fig. 34).
FINE key (3) to continue the program.
31