Snap-On EEWB332B Manual De Operador página 39

E24
Velocity fl uctuations
If the speed of the wheel to keep to the need to
compensate.
• Check that the wheel is not obstructed or impeded
by something.
• Check the power supply.
• Fit the wheel properly.
• Call Technical Support at
E25
Reverse error.
The shaft is rotating at a certain speed but in the wrong
direction.
• Apply the brake.
• Contact Technical Support at
The display clears when rotation stops.
E26
No acceleration.
No shaft acceleration has been registered.
• Contact Technical Support at 800-225-5786.
E27
Slipping registered.
The wheel slips on the shaft.
Fit the wheel correctly.
•
E28
Speed limit reached.
• Contact Technical Support at
E50
Manufacturer's calibration incomplete
• Contact Technical Support at
E51
Calibration failed
• Switch unit off, wait for 20 seconds.
• Switch unit on.
• Retry calibration, or:
• Contact Technical Support at 800-225-5786
E52
The calibration weight is on the opposite side to the
calibration carried out by the manufacturer.
• Fit the User Calibration Weight correctly on
the left side of the fl ange. Repeat Calibration.
• Contact Technical Support at 800-225-5786
800-225-5786.
800-225-5786.
800-225-5786.
800-225-5786.
EEWB332B
E82
Fault during self-test at start-up.
• Switch unit off, wait for 20 seconds.
• Switch unit on.
E92
During the second attempt the gauge arm for distance
and rim diameter was still not in the home position.
Both gauge arms are rendered inoperative.
• Wait 5 seconds, or press the STOP key to
continue.
E500
E501
E502
E503
Laser weight placement indicator failure
• Contact Technical Support at 800-225-5786.
39