Stahlwille SmartCheck USB/DAPTIQ Instrucciones De Uso página 76

Operation
Switching the DPG on
To switch the DPG on, proceed as follows:
➢ Make sure that no torque is applied whilst switching on.
➢ Press the "CLEAR HOLD POWER" button and keep it pressed for
approx. one second.
An audible signal is heard, the LEDs light up once and the display is
switched on.
If the batteries' or rechargeable batteries' state of charge is too low,
the DPG cannot be switched on, or immediately switches off again.
The settings last used are stored. This also applies if no current
supply was available temporarily.
If the DPG is not used, it switches off automatically after approx.
three minutes.
Setting the mode
Three modes are available:
• Track, for general measurement of torques
• Peak Hold, for indicating torque wrenches
• First Peak, for click type torque wrenches.
74