Additional Features; Important Safety Instructions - Furman PRESTIGE Serie Manual Del Propietário

Additional Features

The P-2400 IT offers a switchable laboratory precision digital meter that displays incoming voltage in 1-volt steps or true RMS cur-
rent in 0.1 amp steps. The voltmeter's accuracy is ±1.5 volts and features a tri-color voltage range indicator. This informs the user
whether voltage is in or out of a safe range, even from a distance too great to accurately read the displayed voltage.
SAFETY INFORMATION
To obtain best results from your Furman Prestige Series Power Conditioner, please read this manual carefully before using.
WARNING
To reduce the risk of electrical shock, do not expose this equipment to rain or moisture. Dangerous high voltages are present inside
the enclosure. Do not remove the cover. Refer servicing to qualified personnel only.

IMPORTANT SAFETY INSTRUCTIONS

(Please read prior to installation)
1. Please read and observe all safety and operating instructions before installing your Furman Prestige Series power conditioner.
Retain these instructions for future reference.
2. Your Prestige Series conditioner should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement, or near a swimming pool.
3. Do not place your Prestige Series conditioner near high heat sources such as radiators, heat registers, stoves, or other appliances
that produce extreme heat.
4. The Furman P-2400 IT should only be connected to a 120 VAC, 60Hz, 20 amp grounded electrical outlet. Do not defeat the
ground or change polarization of the power plug.
5. Route the AC power cord and other cables so that they are not likely to be walked on, tripped over, or stressed. Pay particular at-
tention to the condition of the cords and cables at the plugs, and the point where they exit your Furman conditioner. To prevent risk
of fire or injury, damaged cords and cables should be replaced immediately.
6. Clean your Furman conditioner with a damp cloth only. Do not use solvents or abrasive cleaners. Never pour liquid on or into the unit.
7. Your Furman conditioner should be serviced by qualified service personnel when:
• The power supply cord or the plug has been frayed, kinked, or cut.
• Objects have fallen or liquid has spilled into the unit.
• The unit has been exposed to rain or extreme moisture.
• The unit does not appear to operate normally.
• The "Protection OK" indicator is not lit.
• The unit has been dropped, or the enclosure has been damaged.
8. Your Furman conditioner requires that a safety ground be present for proper operation.
9. Do not attempt to service your Furman conditioner beyond what is described in this manual. All other servicing should be re-
ferred to qualified service personnel.
NOTE: Furman's P-2400 IT does not compensate for high or low AC line voltage. If you frequently move your rack to different loca-
tions, derive power from generators, use excessively long extension cords, travel internationally, or are in an area prone to brown-
outs, you may benefit from the use of one of Furman's AC Line Voltage Regulators.
INSTALLATION
The power source into which the P-2400 IT is connected must be adequate for use at 20 amps. We recommend either a 30 amp
circuit, wired with 10 gauge wiring, when continuous operation near 20 amps is anticipated, or a dedicated 20 amp circuit. Consult
a qualified electrician when in doubt.
The P-2400 IT is designed for mounting in a standard 19 inch equipment rack. Because of its weight, the best position is the bottom
slot of the rack. Its toroidal transformer minimizes magnetic leakage, but nevertheless, due to its high capacity, it may radiate a
5