Publicidad
Idiomas disponibles
Idiomas disponibles
Before connecting the appliance, make sure that the supply voltage marked on the Rating Plate
corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
• If you have to change the ceramic hob power cord, the earthing (yellow/green) conductor must
always be 10 mm longer than the line conductors.
• Care must be taken to ensure that the temperature of the mains supply cable does not exceed
50°C.
• If the mains supply cable is damaged, then it must be replaced by an appropriate replacement
which can be obtained from Spares Department.
ASSEMBLY OF CERAMIC HOB:
PREPAZONA THE UNIT FOR A BUILT-IN APPLIANCE
WARNING
• The kitchen units that are in direct contact with the appliances must be heat-proof (min. 95°).
• The appliance can be installed on a work surface with a thickness of between 30 and 40 mm
and near to walls which are higher than the work surface, maintaining a minimum distance of
100 mm.
• Carry out all cutting of the unit and work surface then carefully remove shavings or sawdust
before inserting the appliances.
• To ensure a correct ventilation of the hob please comply with the dimensions shows in figures.
• Always refer to the manufacturer for specific instructions,
• Make sure the surface is level and square and that no part interferes with the space required for
installation
• Prepare the cut as indicated (see installation dimensions).
48
Publicidad
