Publicidad
Idiomas disponibles
Idiomas disponibles
STEP.3
Fix the brackets (4 pcs) on the front side and rear side by screw. Put the hob in the cut-out cabinet,
and make it centered. Ensure that the front edge of the hob is parallel to the side edge of the work
surface.
• IMPORTANT: You must observe the ventilation requirements
shown in the drawing opposite.
• IMPORTANT: There are ventilation holes around the outside of the
hob. YOU MUST ensure that these holes are not blocked by the
work top, when you put the hob into position (see drawing
opposite).
• IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be serviced.
• Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
FITTING GUIDELINES
The ceramic hob is manufactured to work with two-phase alternating
current (400V2N~50Hz). The voltage rating of the ceramic hob heating
elements is 230V. Adapting the ceramic hob to operate with one-phase
current is possible by appropriate bridging in the connection box
according to the connection diagram below. The connection diagram is
also found on the cover of the connection box. Remember that the
connection wire should match the connection type and the power rating
of the ceramic hob. The connection cable must be secured in a strain-
relief clamp.
50
Publicidad
