Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
Remember to connect the safety circuit to the connection box terminal marked with
supply for the ceramic hob must have a safety switch which enables the power to be cut off in case
of emergency. The distance between the working contacts of the safety switch must be at least
3mm.
Before connecting the ceramic hob to the power supply, it is important to read the information on the
data plate and the connection diagram.
Model
JP4EV002082
The cable connections must be in accordance with the diagram located on the bottom of the
⚫
hob.
The cable type must be connected to the corresponding power supply terminal box.
⚫
You should use a good quality screwdriver to carefully, fully tighten ALL of the terminal screws.
⚫
If when the hob is first switched on, only two of the zones work, you should recheck that the
⚫
terminal screws are all fully tightened. This should be done before contacting the Customer Care
Department.
IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 13A
⚫
plug and socket.
This appliance must be wired into a 30 A double pole switched fused spur outlet, having 3 mm
⚫
contact separation and placed in an easily accessible position adjacent to the appliance. It
should not be located above the appliance and no more than 1.25m away from it.
The cable can be looped, if necessary, but make sure that is not kinked or trapped when the
⚫
hob is in position. Care must be taken to avoid the cable being in contact with hot parts of the
appliance.
Wires for each domino hob with 4D models
Adaptive voltage range and wires
220-240 1N～ 50-
60Hz
H05VV-F 3G2.5
380-420 2N～ 50-
60Hz
H05VV-F 4G2.5
H05GG-F 4G2.5
H07RN-F 4G2.5
51
. The electricity
The wiring diagram
KADO K 1/5
KADO XT
Publicidad
