Husqvarna Z560X Manual De Usuario página 8

• Do not operate the product on ground that slopes
more than 10°.
• Move smoothly and slowly on slopes.
• Look out for and do not move across furrows,
holes and bumps. There is a higher risk that the
product overturns on ground that is not flat. Long
grass can hide obstacles.
• Do not cut grass near edges, ditches or banks.
The product can suddenly overturn if a wheel
moves across the edge of a steep slope or a
ditch, or if an edge gives way.
Safety instructions for operation on slopes
• The ROPS is an integral and effective safety
device. Do not remove or alter the ROPS.
• Keep a folding ROPS in the raised and locked
position and use the seat belt when operating the
product.
• Lower a folding ROPS temporarily only when
absolutely necessary. Do not wear the seat belt
when folded down. There is no rollover protection
when a folding ROPS is in the down position.
• Replace a damaged ROPS. Do not repair or
alter.
Personal protective equipment
WARNING:
instructions that follow before you use
the product.
• Use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident
does occur. Let your dealer help you select the
right equipment.
• Always wear approved hearing protection. Long
term exposure to noise can result in permanent
hearing impairment.
• Always wear protective shoes or protective
boots. Steel toes are recommended. Do not use
the product barefoot.
• Wear gloves when necessary, for example
when you attach, examine or clean the cutting
equipment.
• Do not wear loose-fitting clothing, jewelry or
other items that can get caught in moving parts.
• Keep first aid equipment and fire extinguisher
close at hand.
8
Read the warning
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
• Do not use a product with safety devices that
are damaged or do not operate correctly. Do a
check of the safety devices regularly. If the safety
devices are damaged, speak to your Husqvarna
service agent.
• Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are damaged.
Malfunction indicator light
The malfunction indicator light (MIL) shows the
operator if there is a problem with the engine. Refer
to the operator's manual for the engine.
To engage and disengage the Roll Over Protection
Structure (ROPS)
• Remove the 2 pins that hold the ROPS and fold
it rearwards to disengage. Engage the ROPS in
the opposite sequence.
WARNING:
instructions for the ROPS and the
safety belt.
• Do not use the safety belt if the ROPS is
disengaged.
• Always use the safety belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached
and not damaged.
To do a check of the ignition key
• Start and stop the engine to do a check of the
ignition key. Refer to
13 and To stop the engine on page 14 .
• Make sure that the engine starts when you turn
the ignition key to start position.
• Make sure that the engine stops immediately
when you turn the ignition key to stop position.
Read the warning
Obey the following
To start the engine on page
2173 - 001 - 27.06.2023