TECshow NAVIGATOR EXPERT RDM Manual De Usuario página 28

Calling Scenes
1. Press the CHASE button (button lights).
2. Call the desired chase with the number
buttons at the lower right corner (button lights).
- If necessary, use the PAGE but-
ton to switch between the mem-
ory banks 1-15 (LED A lights) and
16-30
- Up to 5 chases can be selected
simultaneously. The chases are
played one after the other. The
LED of the chase currently play-
ing flashes, the others light.
- The display indicates the num-
ber of the chase (e.g. "Chase01")
in the lower line and the current
step (e.g. "Step001).
3. Select the chase running mode with the
button RUN MODE. The mode is indicated by the
LEDs above to the button. See the table at the
right-hand side for a description of the modes.
4. A flashing LED indicates which chase can
be adjusted when several chases are selected si-
multaneously. The chase selected last can be ad-
justed. To adjust a different chase instead, keep
the corresponding number button pressed until
its LED flashes.
5. To stop a chase, press the corresponding
number button so that its LED extinguishes.
P. 28
NAVIGATOR EXPERT RDM
ENGLISH VERSION
(LED B lights).
Overview of running modes
Manual:
The chase can be manually advanced step by step with
the PAN/TILT wheel. The PAN/TILT button must be en-
gaged for this function (SPEED LED lights).
Music:
The individual steps of the chase run to the rhythm of
the music picked up via the internal microphone. The
sensitivity of the sound control is adjustable. For this,
keep the RUN MODE button pressed and turn the PAN/
TILT wheel to adjust a value between 0-100 %. The high-
er the value, the higher the sensitivity.
Auto:
The individual steps of the chase run at the adjusted
speed and fade time. The PAN/TILT button must be en-
gaged for this function (SPEED LED lights).
Use the PAN wheel to adjust the running speed, i.e.
how long a scene is shown, between 10 minutes and
0.1 seconds (indication "Wait"). Alternatively, you can
press the MENU/ESC button twice (tap function). The
time between the two actuations of the button defines
the time until the next change of scene. The display
shortly inserts the setting, e.g. "Speed 5.5S".
Use the TILT wheel to adjust the fade time, i.e. the
time between the steps, between 0 and 30 (indication
"Fade"). The time adjusted is will be taken over in man-
ual and sound-controlled mode.