Safety Instructions; Protection Class; Power Cord - TECshow NAVIGATOR EXPERT RDM Manual De Usuario

2. Introduction
•
Keep this device away from rain and moisture
•
Please read the user manual carefully before use.
•
The device firmware can be updated.
•
Please check if a new version is available online.

3. Safety Instructions

This device has left our premises in absolutely perfect con-
dition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in
this user manual. Damages caused by the disregard of this
user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
Unpacking
•
Please make sure that there are no obvious trans- -
port damages. Should you notice any damages,
do not take the device into operation and imme- -
diately consult your local dealer.
•
Save the package and all packing materials. In
the event that a fixture must be returned to the
factory, it is important that the fixture be returned
in the original factory box and packing

Protection Class

•
This device falls under protection class I. The
power plug must only be plugged into a protec- -
tion class I outlet. The voltage and frequency
must exactly be the same as stated on the device.
•
Wrong voltages or power outlets can lead to the
destruction of the device and mortal shock.

Power Cord

•
Always plug in the power plug least. The power
plug must always be inserted without force. Make
sure that the plug is tightly connected.
•
Never let the power cord come into contact with
other cables! Handle the power cord and all con -
nections with the mains with particular caution!
Never touch them with wet hands, as this could
lead to mortal electrical shock.
•
Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord.
Never operate next to sources of heat or cold.
Disregard can lead to power cord damages, fire or
mortal electrical shock.
•
The cable insert or the female part in the device
must never be strained. There must always be
sufficient cable to the device.
•
Make sure that the power cord is never crimped
or damaged by sharp edges. Check the device
and the power cord from time to time.
•
If extension cords are used, make sure that the
core diameter is sufficient for the required power
consumption of the device. All warnings concern-
ing the power cords are also valid for possible ex-
tension cords.
P. 3
NAVIGATOR EXPERT RDM
ENGLISH VERSION