Operating Determinations - TECshow NAVIGATOR EXPERT RDM Manual De Usuario

4. Operating Determinations

The DMX controller serves for operation of DMX-controlled
light effect devices such as LED spot lights, moving heads
and scanners in discotheques or on stage.
Power Supply
The occupation of the connection cables is as follows:
CABLE INTERNATIONAL PIN
Brown
Blue
Yellow/Green
The earth has to be connected. If the device will be directly
connected with the local power supply network, a discon-
nection switch with a minimum opening of 3 mm at every
pole has to be included in the permanent electrical instal-
lation. The device must only be connected with an electric
installation carried out in compliance with the IEC stand-
ards. The electric installation must be equipped with a
Residual Current Device with max. fault current of 30 mA.
Installation
Do not shake the device. Avoid brute force when installing
or operating the device. When choosing the installation
spot, please make sure that the device is not exposed to
extreme heat, moisture or dust. There should not be any
cables lying around there.
P. 6
NAVIGATOR EXPERT RDM
ENGLISH VERSION
Live L
Neutral
N
Earth
Taking into Operation
Operate the device only after having familiarized with
its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are
the result of unprofessional operation.
The ambient temperature must always be between -5°
C and +45° C. Keep away from direct insulation (particu-
larly in cars) and heaters. The relative humidity must
not exceed 50 % with an ambient temperature of 45° C.
1. This device must only be operated in an alti-
tude between -20 and 2000 m over NN.
2. Never use the device during thunderstorms.
Over voltage could destroy the device. Always discon-
nect the device during thunderstorms.
3. This device must never be operated or stock-
piled in surroundings where splash water, rain, mois-
ture or fog may harm the device. Moisture or very high
humidity can reduce the insulation and lead to mortal
electrical shocks.
4. When using smoke machines, make sure that
the device is never exposed to the direct smoke jet and
is installed in a distance of 0.5 meters between smoke
machine and device.
Ambient Conditions
•
The ambient temperature must always be be-
tween -5° C and +45° C. Keep away from direct
insulation (particularly in cars) and heaters. The
relative humidity must not exceed 50 % with an
ambient temperature of 45° C.
•
This device must only be operated in an altitude
between -20 and 2000 m over NN.
•
Never use the device during thunderstorms. Over
voltage could destroy the device. Always discon-
nect the device during thunderstorms.
•
This device must never be operated or stockpiled
in surroundings where splash water, rain, mois-