What To Do In Case Of Interruption Of The Limescale Removal - Gaggia Milano Anima Prestige Instrucciones De Uso

What to do in case of Interruption of the Limescale Removal

4 Pour the Gaggia descaling solution in the water tank. Fill the tank using
clean water up to the CALC CLEAN level indication. Put the tank back in
the machine. Press the OK button to confirm. The first stage of the desca-
ling clean starts. The machine will start dispensing the descaling solution
at regular intervals. The display shows the descaling clean icon, stage and
duration. The first stage lasts for 20 minutes.
5 Let the machine dispense the descaling solution until the water tank is
empty.
6 Remove the water tank and rinse it.
Fill the tank using clean water up to the CALC CLEAN level indication. Put
7
the tank back in the machine and press OK.
8 Remove the milk carafe and wash it. Fill the milk carafe with water up to
the MIN level indication. Insert the milk carafe into the machine and open
the milk dispensing spout.
9 Remove the container, empty it and put it back under the coffee dispens-
ing spout. Press OK to confirm.
10 The second stage of the cleaning cycle starts, that is the rinse cycle. This
stage lasts for 3 minutes. The display shows the rinse icon and the dura-
tion of this stage.
Note: if the water tank is not filled up to CALC CLEAN level, it may be neces-
sary to repeat the rinse cycle.
11 Wait until the machine does not dispense water anymore. The limescale
removal is over when the display shows a tick.
12 To exit the descaling cleaning cycle, press the OK button. The machine
starts warming up and performs an automatic rinse cycle.
13 Remove the container and empty it.
14 Perform the "Weekly Cleaning of the Milk Carafe" operation to clean the
carafe after the descaling clean.
15 Clean the brew group as described in the "Brew Group Cleaning under
Running Water" chapter.
16 Install a new "INTENZA+" filter into the water tank.
Tip: the "INTENZA+" filter reduces the frequency of the descaling clean.
You can exit the limescale removal pressing the STAND-BY button on the con-
trol panel. In case the limescale removal stops before its completion, perform
the following operations:
1 Empty the water tank and wash it thoroughly.
2 Fill the water tank using running water up to the CALC CLEAN level indi-
cation and switch on the machine again. The machine will warm up and
perform an automatic rinse cycle.
English
25