Fox F36-420 Manual De Instrucciones página 25

ADDITIONAL SAFETY INSTRUCTIONS FOR TILE CUTTERS
1. DO NOT USE the tile cutter until it is completely assembled or installed according to the instructions of this
manual.
2. ALWAYS USE disc protection to "cut completely". This expression means that the piece is cut completely
along is whole thickness.
3. ALWAYS PRESS the piece firmly to the 45° support or to the fence.
4. ALWAYS USE a push-stick to cut small pieces. Never cut pieces that can't be blocked firmly.
5. NEVER WORK freehand. Always use the 45° support or rip fence to place and guide the workpiece.
6. DO NOT PLACE YOURSELF along cutting disc axis. KEEP your hands far from cutting disc trajectory.
7. NEVER PLACE you hands behind or over the cutting disc, and avoid uncomfortable positions of your
hands and body.
8. ALWAYS MOVE the piece against the cutting disc or tool.
9. NEVER TRY to release the cutting disc before the tool is still. If you need to stop cutting, push OFF button
of the switch and wait until the cutting disc is still. Intervene only when the cutting disc is still and without
power supply.
10. AVOID removing the jammed pieces between the cutting disc and the insert if the cutting disc is moving.
Switch off the machine and wait until the cutting disc is still, then intervene.
11. PLACE on tripods or supports the ends of big pieces that stick out laterally or behind the tile cutter; make
sure that the material to be cut is stable, in order to avoid it falling down at the end of the cut.
12. AVOID violent kickbacks (the workpiece is thrown to the operator):
 by always using a correctly sharpened cutting disc;
 by checking the parallelism between the fence and the cutting disc;
 by always using cutting disc protection;
 by not releasing the workpiece unitl it is completely cut;
 by avoiding bent or deformed pieces which have not a straight side which allows to move them forward
evenly along the fence.
13. NEVER use thinners to clean plastic parts. Thinners can melt or damage the material. Only use a damp
cloth to clean plastic parts.
14. ALWAYS USE the tile cutter in a well ventilated environment.
15. DO NOT USE damaged or deformed cutting discs.
16. ONLY USE cutting discs recommended by the manufacturer, compliant to what is indicated in this manual.
17. USE cutting discs suitable for the material to be cut. During cutting disc replacement, check that outer
diameter and bore diameter are correct, use suitable gloves when handling cutting discs or raw materials.
18. USE this tile cutter only to cut tiles.
19. REGULARLY CHECK if the supply cable is damaged, in that case get it repaired by an authorised after-
sales centre. Check regularly the extension cables and replace them if they are damaged.
20. CONNECT and USE earmuffs and dust mask.
21. MAKE SURE that water tank is always full, in order to cool down the cutting disc during tile cutting.
22. NEVER TRY to stop the cutting disc by exerting a lateral pressure on it.
23. When switching the tile cutter on CHECK that the cutting disc is not in contact with the material to be cut.
Do not start cutting until the cutting disc has reached its maximum speed.
24. Before starting to cut, CHECK if the pump is in good conditions. If the pump is damaged, you must not use
the machine.
25. MAKE SURE that the pump is not running dry.
26. NEVER LIFT the pump from the electrical cable, but only from the housing..
EN
19