Electrical Connections; Earthing Instructions - Fox F36-420 Manual De Instrucciones

COLLEGAMENTO DELL'UTENSILE ALLA CORRENTE

ELECTRICAL CONNECTIONS

To supply current to your machine a 230 V 50 Hz alternate voltage equipped with a earthing conductor is
necessary. Ensure that your power supply corresponds to these features, that it is protected by a differential
and magnetothermal switch, and that earthing system is efficient. If your machine does not work when
connected to a socket, check carefully power supply features.

EARTHING INSTRUCTIONS

Socket with earthing system
Earth conductor
In the event of a tool functioning fault or short circuit, the earth connection provides the path of least resistance
for the electrical current and reduces the risk of electrical discharge. This tool is fitted with an electric cable
which includes an earth conductor and a plug with a protective earth contact. The plug must be connected to a
correctly installed socket and earthed in compliance with local standards and regulations. Be sure that your
earthing system is in good conditions and that your plug is protected by a differential and magnetothermal
switch.
Do not modify the plug supplied on the tool. If it does not fit into the socket, have a suitable socket installed by a
qualified electrician. A faulty connection of tool's earth conductor can lead to the risk of electric discharge. The
earth conductor has a green (with or without yellow stripe) insulating sheath to distinguish it from the others.
Should the power cable ever need repairing or replacing, do not connect the earth conductor to a live terminal.
If you fail to fully comprehend or have any doubts whatsoever concerning the earthing instructions, contact a
qualified electrician or maintenance technician. If the power cable is damaged, it must be replaced by an
authorized assistance centre or qualified personnel. Never switch the tool on if the power cable is damaged.
This tool is provided with a plug which must connected to a suitable socket.
EN
Machine's plug
22