Swing Button; Remote Controller Lock - Impecca IPAC16-BRB Manual De Usuario

FAN SPEED SELECTOR
Cycle through different fan speeds from one to four bars (low to high) and AUTO. Auto
speed selects an appropriate fan speed based on ambient temperature and most effi-
cient unit operation.

SWING BUTTON

This unit has 2-Way directional louvers (up and down). When the unit is turned on the
louvers will open to allow air flow. The remote will allow you to adjust the louver setting
during use. Once the unit is powered off the louvers will close.
SLEEP BUTTON
During cooling mode, the sleep button will allow the room temperature to slightly in-
crease for more energy efficient operation.
TIMER (DELAY START/STOP) BUTTON
• While the unit is on, press this button to program a time when the unit will au-
tomatically turn off. While H and the T-OFF indicator are flashing on the remote
control display, use the / buttons to set the shutdown time in 30 minute (.5h)
increments. Press the TIMER button again to save the shut down program.
• When the unit is plugged in but powered off, press this button to program a time
when the unit will automatically turn on. While H and the T-ON indicator are flash-
ing on the remote controller display, use the / buttons to set the delay until
the unit will start up in 30 minute (.5h) increments. Press the TIMER button again
to save the power on program.
• To check the remaining time after a program has been set, simply press the TIMER
button once. To cancel the program, press the TIMER button again.
Note: Delayed start and stop can be set between 30 minutes and 24 hours in 30 minute (.5h)
increments. The unit must remain plugged in for the timer to function properly.

REMOTE CONTROLLER LOCK

The remote controller is equipped with a child lock to prevent inadvertent changes to
unit settings. This is indicated on the remote's LCD.
• To activate the lock: Press the  and  buttons simultaneously.
• To deactivate the lock: Press the  and  buttons simultaneously.
CHANGE TEMPERATURE UNITS (C° OR F°)
While the unit is off, press the  and MODE button simultaneously on the remote
control to toggle the unit readout temperature between Celsius (C°) and Fahren-
heit (F°).
–21– –21–