Publicidad
Idiomas disponibles
Idiomas disponibles
- Fig. 15 -
Width adjustment of basic roof rack.
Advice. Instructions for professional service in case the
position of the bottom ends is not adjusted correctly for
the respective vehicle.
a/ Remove the plastic capping strips on the lower part of
the roof rack -arrows-.
b/ Using a wrench for screws with inner hexagonal (Allen
key), size 5, unscrew both screws to be able to move the
bottom end. Set the basic roof rack in correct position,
see Fig. 10.
c/ Tighten both screws applying 10 Nm torque.
Fit the roof rails to the vehicle and retest the accuracy of the
adjustment.
If the adjustment of the roof rack still does not correspond
with the description of Fig. 10, it has to be repeated.
If the positioning of the roof rack is OK, check the screws
for proper tightening (10 Nm). Otherwise the roof rack
may release or get lost, thus endangering the safety of
other road traffic participants - risk of injury.
Snap back the plastic covers.
GB
Publicidad
