Publicidad
Idiomas disponibles
Idiomas disponibles
you will have access to UVC lighting, proceed to change the lamp and replace the
removed sheets, placing them in the same way they were originally.
5.4.4 Anomalies and Alarms.
The steps to follow in the event of an anomaly or malfunction will be shown below.
Possible causes and possible solutions are listed in the following table. In case of doubt
or if you are not able to solve the error, contact the technical service.
Do not handle the electrical components yourself as there is a danger of death
due to the components being under mains voltage.
ANOMALY
The
equipment
does not
work
Insufficient
temperature
Location of gender
Closing the door
Bad leveling and
Strange or
bad closing of the
excessive
noises
Friction with
moving area of the
Loose fixings
NOTE: if a fault occurs that is not listed in the table, contact your technical
assistance service. The manufacturer reserves the right to modify the
characteristics without prior notice.
ES
POSSIBLE
CAUSE
Check that voltage reaches the refrigerator observing that
No tension
the display is on.
Check that there is no heat source nearby.
Refrigerator
location
Check that the ambient temperature is not above + 40 ° C,
Room
which is the maximum operating temperature of the
temperature
appliance.
Check that the fabric load is perfectly positioned, without
inside the
blocking the air outlets of the indoor fan, and that the time
furniture
that has elapsed since it has been placed is sufficient to cool
the products.
Check that the doors close properly
Check that the condenser is clean: You must bear in mind
Cleaning the
that the cleaner the equipment, the more energy savings,
condenser
especially the finning of the condenser. The frequency will
be determined according to the characteristics of the
premises. If it is dirty, you must call the technical service to
clean it.
Check that the furniture is level and that the doors close
properly
doors
Check that there are no objects rubbing against any
moving element of the equipment.
equipment
Check that the screws (at least the visible ones) are well
tightened.
SOLUTION
34
Publicidad
