Publicidad
Idiomas disponibles
Idiomas disponibles
EN-10
Figure. 21
For adaption of data press the key "Store" (2) (refer to figures 21 and 22) for approx. 1 second. If the program is
stored correctly, the word "StorE" appears in the display "RPM/RCF" (A-1). As a result, the word "programm"
(M10) disappears.
As soon as the key "Store" (2) is released, the word "programm xx" (M10) reappears – the (xx) stands for the
chosen program location.
If all program numbers are occupied you can take an old number that is not necessary anymore and just put in the
new parameters.
3.6.2
Recall of stored programs
To recall stored programs press the key "Prog/Setup" (3) (refer to figure 23) while the lid is already closed. Inside
the display "Time/Prog" (A-4), "programm –"(M10) appears. The desired program number can be pre-selected
with the adjusting dial (4).
In the respective displays the stored values for that program will appear.
If the wrong rotor is inside the centrifuge for the pre-selected program, in the display "RPM/RCF" (A-1), the word
"rotor" (M3) flashes. At the same time the word "FALSE" and the stored rotor number "xx" (M4) will flashing by
turns.
A-1
3.6.3
Leaving program mode
To leave the program mode just press the key "Prog/Setup" (3) (refer to figure 23). Then inside the display
"Time/Prog" (A-4) the word "programm" (M10) appears.
Set the display to "programm--" (M10) with the adjusting dial (4).
M3
M4
Figure. 23
TM
Frontier
Centrifuge FC5707
Figure. 22
A-4
M10
3
4
2
Publicidad
