Publicidad
Idiomas disponibles
Idiomas disponibles
14. SECURE WORK. Use clamps or a vise instead of your hand to hold work. This
safety precaution allows for proper tool operation using both hands.
15. DON'T OVERREACH. Keep proper footing and balance at all times.
16. MAINTAIN TOOLS WITH CARE. Keep tools clean and in good working condition
for maximum safety performance. Follow instructions for lubricating and changing
accessories.
17. DISCONNECT TOOLS BEFORE SERVICING – when changing accessories, such
as blades, bits, cutters, etc.
18. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in
OFF position before plugging in.
19. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for
recommended accessories. The use of improper accessories may increase risk of
injury.
20. MAKE SURE YOU USE THE CORRECT TOOL for the job you are doing.
21. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
22. CHECK DAMAGED PARTS. Before further use of the tool, damaged part(s),
(i.e., guard) should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting and any other condition that may affect
the tools operation. A guard or other part that is damaged should be properly
repaired or replaced.
23. Replace damaged blades/cutters/ grinding wheels immediately. DO NOT USE
DAMAGED BLADES/CUTTERS/GRINDING WHEELS. They may cause bodily
injury.
24. DIRECTION OF FEED. Feed work into the blade/cutter against the direction of
rotation of the blade/cutter only.
25. NEVER LEAVE TOOL RUNNING UNATTENDED. Turn power off. Don't leave tool
until it comes to a complete stop.
26. Double insulated tools (one blade is wider than the other) are equipped with a
polarized plug. This plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install a polarized outlet. Do not change the plug in any way. Double
Insulation eliminates the need for the three wire grounded power cord and
grounded power supply system.
This power tool is supplied with all the relevant safety guards and features, it should be
checked before every operation, this manual should be read and kept in a safe place.
Whilst we warn you all the possible risks attached to using power tools any operator
must have read and understood the manual and apply their own caution and common
sense when using this power tool.
Following this guide will greatly reduce your risk of electric shock or injury.
Only use qualified repair agents to service this power tool.
Only use qualified electrician to repair any damaged wiring.
8
Publicidad
