Publicidad
Idiomas disponibles
Idiomas disponibles
Turning Laser Beam ON/OFF
CAUTION: LASER RADIATION
Do not stare into beam
To turn on the laser beam, press the upper position (Fig.13) of the switch. Press the
lower position to turn off. Laser line is factory adjusted so that it is positioned within 1
mm (0.04") from the side surface of the blade (cutting position). Make a test cut and
position material to be cut accordingly.
NOTE: When laser line is dim and almost or entirely invisible because of the direct
sunlight, relocate the work area to a place not exposed to the direct sunlight.
Using your miter saw
Important Note:
Transporting or moving this machine must only be done with the arm in the
locked position using the transit lock pin. (Fig.5)
When assembling your machine do not connect to the power supply until you have
fully read and understood this manual. After carrying out all checks and making any
necessary adjustments check that the machine switch is in the off position, connect to
the power supply and then switch the machine on and off quickly, this will allow you to
check for any loose blades or accessories without the machine gaining full
speed. Disconnect from the power supply before attempting any adjustments.
During manufacturing your machine is set and calibrated to cut accurately however
movement can occur during transit. If you find that your machine is not cutting
accurately you can make several small adjustments easily.
Re Setting the Table to 90 degrees with the Blade
1. Disconnect the machine from the mains.
2. Lock the arm in the transit position
3. Loosen the Miter Lock Handle. (Fig.6)
4. Align the pointer and table to 0 degrees.
5. Tighten the Miter Lock Handle.
6. Loosen the Bevel Lock Handle. (Fig.7)
7. Position the saw arm to 0 degrees with the blade 90 degrees to the table surface.
8. Tighten the Bevel Lock Handle.
9. Place a 90 deg. Set square against the table and blade (avoiding contact with the
blade teeth) rotate the blade slowly with a gloved hand, checking that it is aligned
correctly. (Fig.10)
10. Adjust the pointer to read 0 degrees. (Fig.11)
11. Retighten Bevel lock handle.
Fence to Table Adjustment
1. Disconnect the machine from the mains.
2. Lock the arm in the transit position
14
Publicidad
