Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT:
Always Use clamp to secure the material. This clamp can be moved to either
side of the table by loosening the locking knob.
Ensure this knob is retightened before using the saw.
Support long lengths using roller support stands.
Slide Cutting
1. Pull and twist the release knob (Fig.9)
2. Pull the saw arm towards you.
3. Position and lock the work piece using the clamp.
4. Grasp the operating handle and squeeze trigger to turn on the machine
5. Allow the machine to free run to its maximum speed before making the cut.
6. Press the guard release trigger
7. Make the cut.
8. Allow blade to completely stop before raising the arm to retrieve the work piece.
Angle (Bevel) Cutting
This type of cut is obtained when the Table is set at 0 degrees and the blade at any
angle required between 0 and 45 degrees left or right (dual bevel).
1. Loosen the Bevel lock. (Fig.7)
2. Move the saw arm to the required angle. (Fig.14)
3. Re-tighten the Bevel lock.
4. Grasp the operating handle and squeeze trigger to turn on the machine.
5. Allow the machine to free run to its maximum speed before making the cut.
6. Make the cut.
7. Allow blade to completely stop before raising the arm to retrieve the work piece.
Changing the blade
DANGER: Do not use any blade larger than the stated capacity of the saw. It may
come into contact with the blade guard and cause harm.
Do not use a blade too thick to allow the outer blade washer to engage with the flats on
the spindle. This will prevent the blade screw from securing the blade on the spindle.
Do not use this saw to cut metal or masonry
1. Disconnect the machine from the power supply
2. Disengage the saw arm by pushing down on the operating handle pull and twist the
release knob.
3. Raise the arm to its highest position.
4. Hold blade guard in the up position and press spindle lock, (Fig.15) (Rotate blade
carefully until blade locks)
5. Use hex key to remove the blade bolt (Fig.8 & 16) by loosening in a clockwise
direction. Note: This bolt has a left hand thread
6. Remove outer blade washer and blade.
7. Clean and lightly oil outer and inner blade washers, do not remove inner blade
16
Publicidad
