Publicidad
Idiomas disponibles
Idiomas disponibles
Avoid sharp objects.
Do not position the cord where it could be subject to traffic passing over it.
Symbols
IMPORTANT: Some of the following symbols may be used on your tool.
V..............................volts
A..............................amperes
Hz.............................hertz
~...............................alternating current
.../m...........................revolutions per minute
..................................class II construction (double insulated)
Kg.............................kilograms
n
..............................No load speed
0
DC
.......................Direct Current
Specific Safety Rules
1. Wear eye protection.
2. Keep hands out of path of saw blade. Avoid contact with any coasting blade. It can
still cause severe injury.
3. Do not operate saw without guards in place.
Check blade guard for proper closing before each use. Do not operate saw if blade
guard does not move freely and close instantly. Never clamp or tie the blade guard
in the open position.
4. Do not perform any operation freehand. The work piece must be secured firmly
against the base and guide fence with a vise during all operations. Never use your
hand to secure the work piece.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop before moving work piece or changing
settings.
7. Unplug tool before changing blade or servicing.
8. To reduce the risk of injury, return carriage to the full rear position after each crosscut
operation.
10. Lock pin which locks the saw head down is for carrying and storage purposes only
and not for any cutting operations.
11. Do not use the tool in the presence of flammable liquids or gases.
12. Check the blade carefully for cracks or damage before each operation. Replace
cracked or damaged blade immediately. Gum and wood pitch hardened on blades
slows the saw and increases potential for kickback. Keep blade clean by first
removing it from tool, then cleaning it with gum and pitch remover, hot water or
kerosene. Never use gasoline to clean blade.
13. While making a slide cut, KICKBACK can occur. KICKBACK occurs when the blade
binds in the work piece during a cutting operation and the saw blade is driven back
.........Conforms to relevant safety standards
11
Publicidad
