Publicidad
Idiomas disponibles
Idiomas disponibles
rapidly towards the operator. Loss of control and serious personal injury can result.
If blade begins to bind during a cutting operation, do not continue to cut and
release switch immediately.
14. Use only flanges specified for this tool.
15. Be careful not to damage the arbor, flanges (especially the installing surface) or
bolt. Damage to these parts could result in blade breakage.
16. Make sure that the turn base is properly secured so it will not move during
operation. Use the holes in the base to fasten the saw to a stable work platform or
bench. NEVER use tool where operator positioning would be awkward.
17. For your safety, remove the chips, small pieces, etc. from the table top before
operation.
18. Avoid cutting nails. Inspect for and remove all nails from the work piece before
operation.
19. Make sure the shaft lock is released before the switch is turned on.
20. Hold the handle firmly. The saw moves up or down slightly during start-up and
stopping.
21. Make sure the blade is not contacting the work piece before the switch is turned
on.
22. Before using the tool on an actual work piece, let it run for a while, watch for
vibration or wobbling that could indicate poor installation or a poorly balanced
blade.
23. Wait until the blade reaches full speed before cutting.
24. Stop operation immediately if you notice anything out of the ordinary.
25. Do not attempt to lock the trigger in the "on" position.
26. Stay alert. Blades are extremely dangerous
27. Use only accessories recommended in this manual. Use of improper accessories
such as abrasive wheels may cause an injury.
28. NEVER hold work piece on right side of blade with left hand or vice versa. This is
called cross armed cutting and exposes user to risk of SERIOUS PERSONAL
INJURY. ALWAYS use vise to secure work piece.
29. Do not abuse cord. Never pull on the cord to disconnect it from the receptacle.
Keep cord away from heat, oil, water and sharp objects.
30. Some materials contain chemicals which may be toxic. Take appropriate measures
to prevent dust inhalation and skin contact. Follow material supplier safety data.
Additional Safety rules for Laser
WARNING: This saw is equipped with a Laser light, DO NOT stare into the beam
because serious injury may occur.
LASER LIGHT - DO NOT STARE INTO BEAM, APERTURE, or into a reflection from
a mirror-like surface.
AVOID EXPOSURE - LASER LIGHT IS EMITTED FROM FRONT GUARD
APERTURE.
Use of controls or adjustments, or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
DO NOT DISASSEMBLE LASER MODULE. The laser is a CLASS II LASER
PRODUCT that can emit laser power up to 1 mw max at 635 nm, which could result
12
Publicidad
